There are three ways to reset a Vigor Router to its factory default settings.
With the router powered on (ACT LED blinking), press the Factory Reset button with a pin, hold a few seconds until the ACT LED starts blinking rapidly, then release the button. After that, the router will restart with the default configuration.
Log into the router's web management page, and go to System Maintenance >> Reboot System. On the web page, choose “Using factory default configuration” and click Reboot Now. After the router reboots, it will be restored to factory default settings.
We can reset the router to factory default by upgrade firmware with an RST file.
1. Go to System Maintenance >> Firmware Upgrade, choose the firmware file with extension “rst”, and click Upgrade.
2. After the firmware upgrade, click Restart to reboot the router, and all the settings will be restored to factory default when the router starts.
Was this helpful?
Sorry about that. Contact Support if you need further assistance, or leave us some comments below to help us improve.