The following steps show how to upgrade the firmware for only the VoIP module of a VigorIPPBX router.
1. First, we need to enable the Web User Interface of VoIP Module (Vigor3300V). Telnet to your IPPBX router, and type command
sys admin drayteker and then
sys VoipWebAct -e 1. It should reply “!! Voip Module WUI enable !!”. Then type
sys re to restart the router.
2. Open a browser and enter
192.168.1.249 (which is the default IP address of VoIP module) in the address bar. Log in by entering username and password (which are
1234 by default).
3. Go to System >> Firmware Upgrade. Select the firmware for Vigor3300 (The file name should be similar to “V3kxxxxx_en.all”), then click Apply.
Was this helpful?
Sorry about that. Contact Support if you need further assistance, or leave us some comments below to help us improve.