Register the router to a SIP server

Vigor V models, which are the model with VoIP function and RJ-11 ports for voice, can register to SIP servers and act as the VoIP gateway for the LAN network. This note is going to demonstrate the setup for SIP registration. In this example, the SIP server at IP address 192.168.92.1

1. Go to VoIP >> General Setting to enable VoIP function. (This menu is available only for the V models)

a screenshot of DrayOS VoIP Settings

2. Go to VoIP >> SIP Accounts and click an available index to edit.

a screenshot of DrayOS SIP accounts list

3. Edit the SIP account as follows:

  1. Give a profile name
  2. For Register via, select the interface where the SIP server is on, which can be WAN, LAN/VPN or PVC/VLAN.
  3. Type the SIP Port which SIP server uses. Usually, it's 5060.
  4. Type the domain name or IP of the SIP server in both Domain/Realm and Proxy
  5. Type Display Name, Account Number/Name, Authentication ID, and Password as the SIP server provided.
  6. You can ring the analog phone on the router's FXS port when there is an incoming call to this SIP account. Select the Ring Port for the phone to ring
  7. Click OK to apply the setting.
a screenshot of DrayOS SIP account settings

4. After clicking OK, the router will try connecting to the SIP server. If the registration was successful, the status of the account will show R, and the phone on the FXS port will be ready to make VoIP calls.

a screenshot of DrayOS SIP account List

Featured Products

Published On:2016-04-25 

Was this helpful?   

book icon

Related Articles