VPN connection between Vigor3900 and Cisco RV series - IPsec

Support Model : Vigor3900Vigor2960

This application note demonstrates how to establish IPsec VPN tunnel between Vigor3900/2960 and Cisco RV router by the following topology.

   

(This article applies to Vigor3900 and Vigor2960, for other models, please refer to the article here.)

 

Cisco RV router setting

1. Go to VPN >> Gateway to Gateway,

  1. Select Interface for VPN connection
  2. Select IKE with Preshared key as Keying Mode
  3. Enter VPN network of Cisco in IP Address and Subnet Mask in Local Group Setup
IPsec VPN Setup on RV series    

      d. Select and and enter Vigor3900's WAN IP in Remote Security Gateway

      e. Enter VPN network of Vigor3900 in IP Address and Subnet Mask in Remote Group Setup

      f. IPsec Setup is flexible, as long as configuration of both routers matche, here we use AES256_SHA1_G5 for IKE phase1, and AES256_SHA1 for IKE phase2, without Perfect Forward Secret, and Preshared Key is 12345678

IPsec VPN Setup on RV Series.PNG    

 

 

Vigor3900 Setting

2. Go to VPN and Remote Access >> VPN Profiles, and click Add on IPsec tab,

  1. Enable the profile
  2. Select WAN Interface used to Dial out
  3. Enter VPN network of Vigor3900 in Local IP/Subnet Mask
  4. Enter WAN IP/Domain of Cisco in Remote Host
  5. Enter VPN network of Cisco in Remote IP/Subnet Mask
  6. Enter Preshared Key
IPsec VPN Profile on Vigor3900.PNG    

      g. In Proposal tab, select the IKE proposal to match the setting on Cisco router

      h. Click Apply

IKE Proposal Setup on Vigor3900    

Go to VPN and Remote Access >> Connect Management page,

  1. Select the IPsec profile
  2. Click Connect
Initiate the IPsec VPN through Connection Management Page    

After VPN is connected successfully, we can see the connection status below.

IPsec VPN established successfully    
Was this article helpful?
43VPN connection between Vigor3900 and Cisco RV series - IPsec has been viewed------ 43 ------times.