How to show VigorAP and VigorSwitch as sub-device behind the Vigor Router on Network tree view.

ACS 2 categorizes the CPEs by network group. However, sometimes it's not easy to know the hierarchy between the CPEs.

For example, we're unable to know which vigor router that this VigorAP connected to fron network tree.

 

Since 2.3.0 version, ACS 2 support a new feature that allows the VigorAP or VigorSwitch is shown as sub-device behind the VigorRouter on Network tree view.

The administrator could enable this feature by setting the id 75 EnableGatewayGrouping as "true" from System >> System Parameter page.

 

After changed, we'll see the VigorAP has been shown as the sub-device of the vigor router.

 

Why my VigorAP and VigorSwitch still not show as sub-device?

1. Make sure your VigorAP and VigorSwitch belong to the same group as the gateway device.

2. Confirm your CPE has upgraded to the latest firmware version.

And it should support the TR-069 parameter : InternetGatewayDevice.X_00507F_LAN.GatewaySerialNumber, we could check it from CPE >> Advanced >> Advanced parameter

Was this article helpful?
29How to show VigorAP and VigorSwitch as sub-device behind the Vigor Router on Network tree view. has been viewed------ 29 ------times.