Is there a way to turn the LEDs, reset button or LAN ports off on Vigor router?

This is possible in firmware version 3.8.8 on the Vigor2862. Also added to this release is the capability to disable the WLAN, USB and LAN ports.  For details please refer to the instructions on Panel Control as follows. By the way, this functionality will be added to other models as their firmware is updated.

LED

By default, the LEDs are enabled, and will illuminate or blink continuously to show the status of the various functions in the router. However, they can be configured to remain off at all times, or remain off until a button is pressed to wake them up.

   

Available settings are explained as follows:

   

Button

The Factory Reset and Wireless ON/OFF/WPS buttons on the front panel are enabled by default and can be enabled or disabled if required. Disabling the Factory Reset button will prevent tampering by unauthorized parties, or to avoid accidental triggering of a router reset when being used wake up LEDs.. Disabling the wireless button will prevent changing the wireless setting when LED Sleep Mode is enabled, and the buttons are primarily used to turn the LEDs on and off.

   

Available settings are explained as follows:

   

USB

The USB ports can be individually enabled or disabled. When a USB port is disabled, attached devices will not be recognized by the router.

   

Available settings are explained as follows:

   

LAN Port

The 4 LAN ports can be individually enabled or disabled. When a LAN port is disabled, attached devices will not be recognized by the router.

   

Available settings are explained as follows:

   
Was this article helpful?
63Is there a way to turn the LEDs, reset button or LAN ports off on Vigor router? has been viewed------ 63 ------times.