We have launched the new version of the DrayTek website, and this content is no longer being maintained.
You will find more information on our new site; however, we will keep this page for a few months.

[Vigor3900] How to access Vigor130 in bridge mode?

Vigor130 can be configured in bridge mode to be a DSL modem by this FAQ. However, we can't access Vigor130 directly when it's in the bridge mode. Hence, we can use WAN advance mode on Vigor3900 to create another interface to access Vigor130 by the following topology.


Note: This application only works when Internet connection has VLAN tag, since Vigor130 can't add tag on its LAN port.

(This article applies to Vigor3900 and Vigor2960, for other models, please refer to the article here.)


Vigor130 Setup

    1. Go to Internet Access >> General Setup,

  1. Enable VLAN Tag insertion without Tag value
  2. Click OK

    2. Go to Internet Access >> MPoA / Static or dynamic IP,

  1. Enable Brigde mode
  2. Click OK

    3. Go to LAN >> General Setup,

  1. Change LAN IP to be different from WAN network
  2. Disable DHCP Server
  3. Click OK



Vigor3900 setup

    4. Go to WAN >> General Setup and change Mode from Basic to Advance,

  1. Edit WAN configuration for Internet connection
  2. Enable VLAN Tag
  3. Enter VLAN ID as ISP requires

    5. Click Add to create another WAN profile to access Vigor130,

  1. Enable the profile
  2. Select WAN Port which connect to Vigor130
  3. Select Static as IPv4 mode

       d. Enter static IP to access Vigor130 in static tab


Go to Dashbroad of Vigor3900 to make sure WAN profile to access Vigor130 is up.


LAN client of Vigor3900 now can access Vigor130 directly via its LAN IP .

Was this article helpful?
41[Vigor3900] How to access Vigor130 in bridge mode? has been viewed------ 41 ------times.