|
Q.
How do I telnet into Vigor router ?
Telnet is one of the old DOS commands still supported by Windows,
but without a Windows graphical interface. From the windows'
Start menu, select " Run... " and enter "telnet
192.168.1.1 ( as shown below ) and click OK.
A command Prompt window will open, and you will be asked for a Password. If you have set the Administrator Password for
your router, enter it here, If you have not set the Administrator Password just press [ Enter ], and a warning message will
be displayed.
Enter commands for the Vigor CLI. You can use question-mark to view available commands, or the correct syntax for a command.
When you have finished entering Vigor CLI/telnet commands, enter " quit " to close the telnet windows.
|
|
|
Page last modified : 13 October 2008 |