|
Establishing IPSec tunnel from WinXP PC to Vigor
router over wireless connection in the same LAN.
Server (Vigor Router) settings:
a. Select 64-bits WEP for wireless connections for the Vigor
Router.
b. In the web configuration age, select Wireless LAN Setup
-› Access Control.
c. Tick "Enable Access Control".
d. Enter the Mac Address for this wireless NIC, and tick "Must
Use VPN over WLAN" and click "Add".
e. Enter the VPN Server IP Address for WLAN, and then click
"OK".
f. From the web configuration page, select VPN and Remote
access Setup -› Remote Access User Setup (Tele-worker).
g. Tick "Enable this account".
h. Select "IPSec tunnel".
i. Click OK.
j. From the web configuration page, select VPN and Remote
Access Setup -› VPN IKE/IPSec General Setup.
k. Enter codes for "IKE Pre-Shared Key".
l. Select an IPSec Security Method.
m. Click "OK" to complete he setup so the specified user can
dial (make connection) n to Vigor router over a wireless connection.
n. Select System Management VPN connection Management, select
the tunnel in which to "Dial" into. The green text then show
the status for the VPN connection.
Client Setting:
a. At the client PC, configure the SSID and use either 40-bits
or 64-bits WEP for the wireless connection.
b. Release or renew IP to check that the wireless interface
has obtained the correct IP address and subnet mask 255.255.255.252.
c. Download DrayTek's Smart VPN Client tool from this link
: http://www.draytek.com/support/download.php
. Select your router code and download the respective VPN
tool Install the downloaded tool on the PC.
d. From the Start menu, click All Programs -› Smart
VPN Client.
e. Click "configure" and restart the computer.
f. Click setup.
g. Type the VPN server's IP, select IPSec Tunnel and click
"OK".
h. Select "MY IP", type both the Remote Subnet and Remote
Subnet Mask as 0.0.0.0. Select "Security Method" and type
the Pre-Shared Key.
i. Click "Active".
j. Open the DOS Command Prompt and perform a ping (e.g. to
a DNS server) to trigger the IPSec tunnel. The Dial-in connection
is established when the ping is successful.
|
|
|
Page last modified : 13 October 2008 |