|
If Vigor Router is configured as the VPN client,
please follow the Setup below:
1. Common Settings:
a. Type the Profile
Name.
b. Select "Enable this Profile".
c. Select Dial-Out and set the Idle Timeout
as 0 to retain this tunnel till terminated by the remote site.
If Always on is selected, please select "Enable PING
to Keep alive and type the any remote network IP in the "PING
to the IP" field, Vigor will try to reconnect if the
tunnel is broken.
2. Dial-Out Settings:
a. Enable the
IPSec tunnel.
b. Type the IP address
or host name of VPN server.
c. Type
the IKE Pre-shared Key.
d. Enable the
IPSec Security Method.
e. click the
Advance button. Enable the "Aggressive mode" and
type the Local ID (you may use IP address, email, or a string
as Peer ID).
4. TCP/IP Network Settings:
Fill in
the Remote Network IP and Remote Network mask.
If Vigor Router is configured as VPN Server,
please follow the Setup below:
1. Common Settings:
a. Type the Profile
Name.
b. Select "Enable this Profile".
c. Select Dial-In and set the Idle Timeout
as 0 to retain this tunnel till terminated by the remote site.
3. Dial-in Settings:
a. Enable the IPSec
tunnel.
b. Enable the Specify Remote
VPN Gateway.
c. Type the Peer ID(you
may use IP address, email, or a string as Peer ID).
d.
Type the IKE Pre-shared Key.
e. Enable
the IPSec Security Method.
4. TCP/IP Network Settings:
Type the
Remote Network IP and Remote Network mask.
For Netscreen Setup:
1. Please click " Objects " -› " Address
" -› " List " field on the left menu.
Select " Trust " and click New
to add Netscreen's LAN address.
2. Type the Address Name.
Select and
type the IP/Netmask.
Click ok.
3. Select " Untrust " and click New to add Vigor's
LAN address.
4. Type the Address Name.
Select and
type the IP/Netmask.
Click ok.
5. Please click " VPN " -› " AutoKey
Advanced " on the left menu and click New to add the
Gateway, then
Type the Gateway Name.
Select Dynamic IP Address.
Type
the Peer ID fae@draytek.com
Type the Preshared Key and then click Ok.
Click Advanced.
6. Select the Proposal for Vigor Router.
Select
aggressive mode.
Click Return.
7. Please click " VPN " -› " AutoKey
IKE" on the left menu and click New to add the AutoIKE.
Type the VPN Name.
Select
Remote Gateway which you set in the AutoKey Advanced.
Click Ok.
Click Advanced.
8. Select Proposal for Vigor Router.
Click
Return.
9. Please click "Policy" on the left menu.
Select
source Address which is local LAN.
Select
Destination Address which is Vigor's LAN.
Select
Service.
Select "Tunnel" of
Action.
Select VPN tunnel which you
set in AutoKey IKE(P2) and then click ok.
10. Please click "Policy" on the left menu.
Select source Address which is Vigor's LAN.
Select Destination Address which is Local
LAN.
Select Service.
Select
"Tunnel" of Action.
Select
VPN tunnel which you set in AutoKey IKE(P2) and then click
ok.
|
|