|
Vigor Settings (
Dial Out )
Create a LAN-to-LAN Dialler Profile in Advanced Set-up.
1. Common Settings:
a. Enter a Profile Name.
b. Select "Enable this Profile".
c. Select "Dial-Out" and set the Idle Timeout to "0" to keep this tunnel open until terminated by the remote site.
If Always On is selected, select "Enable PING to keep alive " and type a remote network IP in "PING to the IP" and Vigor will try to reconnect to this remote IP if the tunnel is broken.
2. Dial-Out Settings:
a. Tick "IPSec Tunnel".
b. Enter the IP address or the host name of the SonicWall.
c. Enter the IKE Pre-shared Key.
d. Select an IPSec Security Method: Medium (AH) or High (ESP).
4. TCP/IP Network Settings:
Enter Remote SonicWall Network IP and Remote Network Mask.
SonicWall Firewall Settings:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
After connection successfully established:
From Main menu, select System Management -> VPN Connection Management, and check the connection status for a dial-out connection (to the SonicWall).
|
|
|
Page last modified : 13 October 2008 |