|
a. For VPN Server Setup:
1. Common Settings:
a. Type the Profile
Name.
b. Select "Enable this Profile".
c. Select Dial-In and set the Idle Timeout
as 0 to retain this tunnel till terminated by the remote site.
3. Dial-in Settings:
a. Enable the L2TP
with IPSec Policy and select Must.
b.
Enable the Specify Remote VPN Gateway.
c.Type
the Peer VPN Server IP.
d. Type the
Username, Password and IKE Pre-shared Key.
e.
Enable the IPSec Security Method and select the DES or 3DES.
4. TCP/IP Network Settings:
Type the
Remote Network IP and Remote Network mask.
When VPN client successfully dials in, you may check the connection
status in System Management -› VPN Connection Management.
b. For VPN Client Setup:
1. Common Settings:
a. Type the Profile
Name.
b. Select "Enable this Profile".
c. Select Dial-Out and set the Idle Timeout
as 0 to retain this tunnel till terminated by the remote site.
If you select Always on, Vigor will try to reconnect if the
tunnel is broken.
2. Dial-Out Settings:
a. Enable the
L2TP with IPSec Policy and select Must.
b.Type
the IP address or host name of VPN server.
c.
Type the Username, Password and IKE Pre-shared Key.
d.
Enable the IPSec Security Method and select the DES or 3DES.
4. TCP/IP Network Settings:
Type the
Remote Network IP and Remote Network mask.
dials out, you may check the connection status in System Management
-› VPN Connection Management.
|
|
|
Page last modified : 13 October 2008 |