|
a. For Remote Dial-in Sever( Vigor router ) Settings:
1. On Vigor's Web configuration page, click VPN and Remote
Access Setup -> Remote Dial-In User Setup. Then click the
Index to setup the Remote Dial-In User Account.
2.
a. Select "Enable this account".
b. Set the Idle Timeout as 0 to retain this
tunnel till terminated by the remote site.
c.
Enable the IPSec Tunnel.
3. In Vigor's web configuration page, click VPN and Remote
Access Setup>VPN IKE/IPSec General Setup to type the IKE
Pre-Shared Key. And then click ok. Now this specified user
can dial into Vigor router.
4. When the user successfully dials in, you can see the connection
status in System Management->VPN Connection Management.
b. From SSH Sentinel settings:
1. Run the SSH Sentinel Policy Editor.
2. Click Key Management page and Add.
3. Select Create a preshared key.
4. Input the pre-shared key.
5. Click Security Policy page and select VPN Connections as
Policy. Click Add.
6. Type the remote IP address and Remote network and select
the Authentication key.
7. Select legacy in Proposal template. Click "Settings"
to configure Proposal.
8. Select the "main mode" on IKE proposal and enable"Attach
only the selected values to the proposal" as
below. Click ok.
9. click the "Diagnostics" to test this VPN connection.
10. Then SSH have completed the Diagnostics test.
11. Run the specified profile and try to establish the VPN
tunnel.
12. Finally, you could verify the VPN connection on SSH
Sentinel Statistic.
|
|
|
Page last modified : 13 October 2008 |