Vigor Router to Vigor Router - L2TP over IPsec

Support Model :
  • Tags :

This note is going to demonstrate how to establish L2TP over IPsec between two Vigor Routers with the following topology.

   

Setting up VPN server

1. Set up IPsec pre-shared key, go to VPN and Remote Access >> IPsec General Setup, type "Pre-Shared Key" and confirm it, then click "OK" to apply.

   

2. Set up VPN profile, go to VPN and Remote Access >> LAN to LAN and click an available index to create VPN profile.

   

3. Give a profile name and enable it, select "Dial-in" as Call Direction.

   

4. In Dial-In Settings, select "L2TP" and set IPsec Policy as "Must", type Username and Password.

   

5. In TCP/IP Network Settings, enter the LAN IP and Mask of VPN client as Remote Network IP/ Mask. Click "OK" to apply.

   

Setting up VPN client

6. Set up VPN profile on VPN Client Router, go to VPN and Remote Access >> LAN to LAN and click an available index to create VPN profile.

   

7. In Common Settings, give a profile name and enable it, select "Dial-out" as Call Direction.

   

8. In Dial-Out Setting,

  1. select "L2TP" and set IPsec Policy as "Must",
  2. enter the IP or domain name of VPN server in Server IP/Host Name for VPN
  3. Type the Username, Password, and the IKE Pre-Shared Key that has configured on VPN server.
   

9. In TCP/IP Network Settings, type the LAN IP and Mask of VPN Server as Remote Network IP/ Mask. Click "OK" to apply.

   

Establishing the VPN tunnel

10. Now go to VPN and Remote Access >> Connection Management of VPN Clientrouter, and click "Dial" to establish VPN. After VPN tunnel is established successfully, we can find the VPN status below.

   
Was this article helpful ?
47Vigor Router to Vigor Router - L2TP over IPsec has been viewed------ 47 ------times.